Cisco Catalyst WS-C3650-48TD-E is next generation of enterprise-level stackable access layer
switch and integrates with 48 Gigabit Ethernet ports and?2 x 10G
SFP+ & 2 x 1G SFP uplink ports in LAN base feature set.
Quick Specs
Table 1 shows the Quick Specs.
| Product Code | WS-C3650-48TD-E |
| Enclosure Type | Rack-mountable - 1U |
| Feature Set | IP Services |
| Uplink Interfaces | 2 x 10G SFP+ & 2 x 1G SFP |
| Ports | 48 x 10/100/1000 Ethernet ports |
| Maximum stacking number | 9 |
| Stack bandwidth | 160Gbps |
| Forwarding Performance | 104.16Mpps |
| Switching Capacity | 176Gbps |
| RAM | 4 GB |
| Flash Memory | 2 GB |
| Number of AP per switch/stack | 50 |
| Number of wireless clients per switch/stack | 1000 |
| Dimensions | 44.5 x 44.8 x 4.4 cm |
High-Performance IP Routing
The Cisco Express Forwarding hardware routing architecture delivers
extremely high-performance IP routing in the Cisco Catalyst 3650
Series Switches:
●IP unicast routing protocols (static, Routing Information Protocol
Version 1 [RIPv1], and RIPv2, RIPng, Enhanced Interior Gateway
Routing Protocol [EIGRP] stub) are supported for small-network
routing applications with the IP Base feature set. Limited static
routing with the LAN Base feature set. Equal-cost routing
facilitates Layer 3 load balancing and redundancy across the stack.
●Advanced IP unicast routing protocols (Open Shortest Path First
[OSPF], EIGRP, Border Gateway Protocol Version 4 [BGPv4], and
Intermediate System-to-Intermediate System Version 4 [IS-ISv4]) are
supported for load balancing and constructing scalable LANs. IPv6
routing (OSPFv3, EIGRPv6) is supported in hardware for maximum
performance. OSPF for routed access is included in the IP Base
image. The IP Services feature set is required for full OSPF,
EIGRP, BGPv4, and IS-ISv4.
●Policy-based routing (PBR) allows superior control by facilitating
flow redirection regardless of the routing protocol configured.
Virtual routing and forwarding (VRF)-Lite enables a service
provider to support two or more VPNs, with overlapping IP
addresses. The IP Base feature set is required.
●Protocol-independent multicast (PIM) for IP multicast routing is
supported, including PIM sparse mode (PIM‑SM), PIM dense mode
(PIM-DM), PIM sparse-dense mode, and source-specific multicast
(SSM). The IP Services feature set is required.
●IPv6 addressing is supported on interfaces with appropriate show
commands for monitoring and troubleshooting.
